High Attack 115 Set Builder

The High Attack Flare Cut Sharpening Set is here!

Turn any graver into a High Attack 115 degree graver with parallel 20 degree heels.

The High Attack 115 degree graver is especially good at bright flare cuts in tight or obstructed places.  It has a true 115 Degree cutting tip, which is typically wider than the tip you get from putting heels on a 120 Degree pre-shaped graver.  The V tip makes it easier to control than a flat graver, and you can get extraordinarily flashy cuts without cutting too deep.

You don't have to learn complicated geometry any more to turn any graver into a 115 degree graver with 20 degree heels and a 50 degree face.  Using the Graver Slide Sharpening System, you can shape, sharpen and polish any graver accurately and repeatedly.  This graver works well in almost all materials and is designed for comfortable ergonomics.

Works with

• High Speed Steel Square Blanks
• Carbide blanks
• Quick Sharp Carbide Micro Gravers
• Repurposed jewelry burs
• Pre shaped gravers that you want to convert

Your gravers can be any length.  Can be used with a powered hone, sharpening stones, or our Engraver.com 5 inch Sharpening Disk Holder with diamond wheels or polishing film.

Build a set around this single Sharpening Block.  Get only what you need. 

Options include:

• 50 degree Face Fixer - needed to make this graver, but if you already have one, you don't have to buy a second one
• Tower and Slimmer - needed to make this graver, but like the Face Fixer, you only need one
• Set of 3 Collets - gravers need to be in a Universal Collet to properly index in a Sharpening Block, but if you already have them, you don't need more
• Diamond Disks and Holder - economical alternative to a powered hone, but not necessary if you have a hone or a good set of sharpening stones

Engraver.com's Universal Collets are required for this sharpening system.  These come with the PulseGraver® or can be added as an option to this set.