Inside Ring Engraving Block Set Builder

Engrave the Inside of Rings and Other Concave Areas

A special tool for Jewelers and Engravers – the Inside Ring Engraving Block.  Part of the Graver Slide™ Sharpening System, this block makes a graver with a special geometry uniquely suited for tight areas characteristic of inside ring engraving.

The 103 degree geometry with 25 degree parallel heels and a 45 degree face gives you an especially high attack angle that lets you engrave in a concave area or inside of a ring while expanding the range of possible curves before you hit an edge with the graver.  This geometry is from Joacim Jansson - it's his favorite graver, and the block is his favorite color!

Works with

• High Speed Steel Square Blanks
• Carbide blanks
• Quick Sharp Carbide Micro Gravers
• Repurposed jewelry burs
• Pre shaped gravers that you want to convert

Your gravers can be any length.  Can be used with a powered hone, sharpening stones, or our Engraver.com 5 inch Sharpening Disk Holder with diamond wheels or polishing film.

Build a set around this single Sharpening Block.  Get only what you need. 

Options include:

• 45 degree Face Fixer - needed to make this graver, but if you already have one, you don't have to buy a second one
• Tower and Slimmer - needed to make this graver, but like the Face Fixer, you only need one
• Set of 3 Collets - gravers need to be in a Universal Collet to properly index in a Sharpening Block, but if you already have them, you don't need more
• Diamond Disks and Holder - economical alternative to a powered hone, but not necessary if you have a hone or a good set of sharpening stones

Engraver.com's Universal Collets are required for this sharpening system.  These come with the PulseGraver® or can be added as an option to this set.